HP 3600 v2 series Configuration Manual page 138

<SwitchC> system-view
[SwitchC] ospf
[SwitchC-ospf-1] area 0
[SwitchC-ospf-1-area-0.0.0.0] network 11.1.1.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.0] network 13.1.1.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.0] quit
[SwitchC-ospf-1] quit
Configure BFD.
3.
# Enable BFD on Switch A and configure BFD parameters.
[SwitchA] bfd session init-mode active
[SwitchA] interface vlan-interface 10
[SwitchA-Vlan-interface10] ospf bfd enable
[SwitchA-Vlan-interface10] bfd min-transmit-interval 500
[SwitchA-Vlan-interface10] bfd min-receive-interval 500
[SwitchA-Vlan-interface10] bfd detect-multiplier 7
[SwitchA-Vlan-interface10] quit
[SwitchA] quit
# Enable BFD on Switch B and configure BFD parameters.
[SwitchB] bfd session init-mode active
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ospf bfd enable
[SwitchB-Vlan-interface10] bfd min-transmit-interval 500
[SwitchB-Vlan-interface10] bfd min-receive-interval 500
[SwitchB-Vlan-interface10] bfd detect-multiplier 6
Verify the configuration.
4.
The following operations are performed on Switch A. The operations on Switch B and Switch C are
similar, and are not shown.
# Display the BFD information of Switch A.
<SwitchA> display bfd session
Total Session Num: 1
Session Working Under Ctrl Mode:
LD/RD SourceAddr
3/1 10.1.0.102
# Display routes to 120.1.1.0/24 on Switch A, and you can see that Switch A communicates with Switch
B through the Layer 2 switch.
<SwitchA> display ip routing-table 120.1.1.0 verbose
Routing Table : Public
Summary Count : 2
Destination: 120.1.1.0/24
Protocol: OSPF
Preference: 0
IpPrecedence:
NextHop: 192.168.0.100
BkNextHop: 0.0.0.0
RelyNextHop: 0.0.0.0
Tunnel ID: 0x0
Init Mode: Active
DestAddr State Holdtime Interface
10.1.0.100 Up
Process ID: 0
Cost: 2
QosLcId:
Interface: Vlan-interface10
BkInterface:
Neighbor : 0.0.0.0
Label: NULL
126
1700ms vlan10