Task
Configuring BFD for IPv6 BGP
Configuring IPv6 BGP basic functions
Configuration prerequisites
Before configuring IPv6 BGP basic functions, complete the following tasks:
Specify IP addresses for interfaces
•
Enable IPv6
•
NOTE:
Create a peer group before configuring basic functions for it. For related information, see
IPv6 BGP peer
Specifying an IPv6 BGP peer
Follow these steps to configure an IPv6 BGP peer:
To do...
Enter system view
Enter BGP view
Specify a router ID
Enter IPv6 address family view
Specify an IPv6 peer
Injecting a local IPv6 route
Follow these steps to configure advertise a local route into the routing table:
To do...
Enter system view
Enter BGP view
Enter IPv6 address family view
Inject a local route into the IPv6
BGP routing table
Configuring an IPv6 BGP route reflector
group."
Use the command...
system-view
bgp as-number
router-id router-id
ipv6-family
peer ipv6-address as-number
as-number
Use the command...
system-view
bgp as-number
ipv6-family
network ipv6-address prefix-length
[ short-cut | route-policy
route-policy-name ]
329
Remarks
Optional
Optional
"Configuring
Remarks
—
—
Optional
Required if no IP addresses are
configured for any interfaces.
—
Required
Remarks
—
—
—
Required
Not added by default