HP 3600 v2 series Configuration Manual page 418

To do...
Create a RIP process for a
VPN instance and enter RIP
view
Enable RIP on the interface
attached to the specified
network
Redistribute the VPN routes
Configure the default cost
value for the redistributed
routes
NOTE:
For more information about RIP, see
Configuring OSPF between MCE and PE
Follow these steps to configure OSPF between MCE and PE:
To do...
Enter system view
Create an OSPF
process for a VPN
instance and enter
OSPF view
Disable routing loop
detection
Configure the OSPF
domain ID
Redistribute the VPN
routes
Configure a filtering
policy to filter the
redistributed routes
Configure the default
parameters for
redistributed routes
(cost, route number,
tag, and type)
Use the command...
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
default cost value
Layer 3—IP Routing Configuration Guide
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
vpn-instance-capability simple
domain-id domain-id [ secondary ]
import-route protocol [ process-id |
allow-ibgp ] [ cost cost | type type | tag
tag | route-policy route-policy-name ] *
filter-policy { acl-number | ip-prefix
ip-prefix-name } export [ protocol
[ process-id ] ]
default { cost cost | limit limit | tag tag |
type type } *
406
Remarks
Required
Required
By default, RIP is disabled on
an interface.
Required
By default, no route of any
other routing protocol is
redistributed into RIP.
Optional
0 by default
.
Remarks
—
Required
Required
Disabled by default
You must disable routing loop detection
for a VPN OSPF process on the MCE.
Otherwise, the MCE cannot receive OSPF
routes from the PE.
Optional
0 by default
Required
By default, no route of any other routing
protocol is redistributed into OSPF.
Optional
By default, redistributed routes are not
filtered.
Optional
The default cost is 1, the default maximum
number of routes redistributed per time is
1000, the default tag is 1, and default
type of redistributed routes is Type-2.