HP 3600 v2 series Configuration Manual page 414

To do...
Configure the default cost value for
the redistributed routes
NOTE:
For more information about RIP, see
Configuring OSPF between MCE and VPN site
An OSPF process belongs to the public network or a single VPN instance. If you create an OSPF process
without binding it to a VPN instance, the process belongs to the public network.
By configuring OSPF process-to-VPN instance bindings on a MCE, you allow routes of different VPNs to
be exchanged between the MCE and the sites through different OSPF processes, ensuring the separation
and security of VPN routes.
Follow these steps to configure OSPF between MCE and VPN site:
To do...
Enter system view
Create an OSPF process for a VPN
instance and enter OSPF view
Configure the OSPF domain ID
Redistribute remote site routes
advertised by the PE
Create an OSPF area and enter
OSPF area view
Enable OSPF on the interface
attached to the specified network
in the area
Use the command...
default cost value
Layer 3—IP Routing Configuration Guide
Use the command...
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
domain-id domain-id [ secondary ]
import-route protocol [ process-id
| allow-ibgp ] [ cost cost | type
type | tag tag | route-policy
route-policy-name ] *
area area-id
network ip-address wildcard-mask
402
Remarks
Optional
0 by default
.
Remarks
—
Required
Perform this configuration on the
MCE. On a VPN site, create a
normal OSPF process.
Optional
0 by default.
Perform this configuration on the
MCE. On a VPN site, perform the
common OSPF configuration.
Required
By default, no route of any other
routing protocol is redistributed
into OSPF.
Required
By default, no OSPF area is
created.
Required
By default, an interface neither
belongs to any area nor runs
OSPF.