HP 3600 v2 series Configuration Manual page 126

Neighbors
Area 0.0.0.0 interface 192.168.1.4(Vlan-interface1)'s neighbors
Router ID: 1.1.1.1
State: Full Mode:Nbr is
DR: 192.168.1.4
Dead timer due in 31
Neighbor is up for 00:11:17
Authentication Sequence: [ 0 ]
Router ID: 2.2.2.2
State: Full Mode:Nbr is
DR: 192.168.1.4
Dead timer due in 35
Neighbor is up for 00:11:19
Authentication Sequence: [ 0 ]
Router ID: 3.3.3.3
State: Full Mode:Nbr is
DR: 192.168.1.4
Dead timer due in 33
Neighbor is up for 00:11:15
Authentication Sequence: [ 0 ]
The DR and BDR have not changed.
NOTE:
In the above output, you can find the priority configuration does not take effect immediately.
Restart OSPF process.
4.
# Restart the OSPF process of Switch D.
<SwitchD> reset ospf 1 process
Warning : Reset OSPF process? [Y/N]:y
# Display neighbor information on Switch D.
<SwitchD> display ospf peer verbose
OSPF Process 1 with Router ID 4.4.4.4
Neighbors
Area 0.0.0.0 interface 192.168.1.4(Vlan-interface1)'s neighbors
Router ID: 1.1.1.1
State: Full Mode: Nbr is Slave
DR: 192.168.1.1
Dead timer due in 39
Neighbor is up for 00:01:40
Authentication Sequence: [ 0 ]
Router ID: 2.2.2.2
State: 2-Way Mode: None
Address: 192.168.1.1
Slave Priority: 100
BDR: 192.168.1.3 MTU: 0
sec
Address: 192.168.1.2
Slave Priority: 0
BDR: 192.168.1.3 MTU: 0
sec
Address: 192.168.1.3
Slave Priority: 2
BDR: 192.168.1.3 MTU: 0
sec
Address: 192.168.1.1
Priority: 100
BDR: 192.168.1.3 MTU: 0
sec
Address: 192.168.1.2
Priority: 0
114
GR State: Normal
GR State: Normal
GR State: Normal
GR State: Normal
GR State: Normal