Ipv6 Pbr Configuration Example (Using A Qos Policy) - HP 3600 v2 series Configuration Manual

Configuration procedure
# Configure ACL 2000.
<SwitchA> system-view
[SwitchA] acl number 2000
[SwitchA-acl-basic-2000] rule 0 permit source any
[SwitchA-acl-basic-2000] quit
# Define a match criterion for class a to match ACL 2000.
[SwitchA] traffic classifier a
[SwitchA-classifier-a] if-match acl 2000
[SwitchA-classifier-a] quit
# Configure the action of redirecting traffic to the next hop 202.1.1.2 for behavior a.
[SwitchA] traffic behavior a
[SwitchA-behavior-a] redirect next-hop 202.1.1.2
[SwitchA-behavior-a] quit
# Associate class a with behavior a in QoS policy a.
[SwitchA] qos policy a
[SwitchA-qospolicy-a] classifier a behavior a
[SwitchA-qospolicy-a] quit
# Apply QoS policy a to the incoming traffic of Ethernet 1/0/1.
[SwitchA] interface Ethernet 1/0/1
[SwitchA-Ethernet1/0/1] qos apply policy a inbound
Verification
After completing the configuration, verify that when Switch A receives packets with destination IP address
201.1.1.2, it forwards the packets to Switch C instead of Switch B.

IPv6 PBR configuration example (using a QoS policy)

Network requirements
As shown in
202::2.
Figure 125 Network diagram
Configuration procedure
# Configure IPv6 ACL 2000.
Figure 125, redirect all packets received on Ethernet 1/0/1 of Switch A to the next hop
389