HP 3600 v2 series Configuration Manual page 431

For VPN 1, advertise interface addresses on the two MCEs in area 0, making the entire VPN a single
OSPF domain. For VPN 2, advertise interface addresses for RIP and OSPF calculations, and in addition,
redistribute OSPF routes to RIP and RIP routes to OSPF on MCE 1.
Figure 134 Network topology of VPN 1 with the MCEs
Figure 135 Network topology of VPN 2 with the MCEs
Configuration procedure
Configure MCE 1.
1.
# Create VLAN 100 and VLAN 101, configure Ethernet 1/0/15 as a trunk port, and add it to the two
VLANs.
<MCE1> system-view
[MCE1] vlan 100 to 101
[MCE1] interface Ethernet 1/0/15
[MCE1-Ethernet1/0/15] port link-type trunk
[MCE1-Ethernet1/0/15] port trunk permit vlan 100 101
[MCE1-Ethernet1/0/15] quit
# Create VLAN interfaces, and configure IP addresses for them.
[MCE1] interface vlan-interface 100
[MCE1-Vlan-interface100] ip address 192.168.1.1 255.255.255.0
[MCE1-Vlan-interface100] quit
[MCE1] interface vlan-interface 101
[MCE1-Vlan-interface101] ip address 192.168.2.1 255.255.255.0
[MCE1-Vlan-interface101] quit
# Create the interface Tunnel0.
[MCE1] interface tunnel 0
# Configure an IP address for the Tunnel0 interface.
[MCE1-Tunnel0] ip address 10.1.1.1 255.255.255.0
# Specify the tunnel protocol as GRE.
[MCE1-Tunnel0] tunnel-protocol gre
419