Troubleshooting Ospfv3 Configuration; No Ospfv3 Neighbor Relationship Established - HP 3600 v2 series Configuration Manual

[SwitchC-ipsec-policy-manual-policy002-10] quit
Apply the IPsec policies in areas.
4.
# Configure Switch A.
[SwitchA] ospfv3 1
[SwitchA-ospfv3-1] area 1
[SwitchA-ospfv3-1-area-0.0.0.1] enable ipsec-policy policy001
[SwitchA-ospfv3-1-area-0.0.0.1] quit
[SwitchA-ospfv3-1] quit
# Configure Switch B.
[SwitchB] ospfv3 1
[SwitchB-ospfv3-1] area 0
[SwitchB-ospfv3-1-area-0.0.0.0] enable ipsec-policy policy002
[SwitchB-ospfv3-1-area-0.0.0.0] quit
[SwitchB-ospfv3-1] area 1
[SwitchB-ospfv3-1-area-0.0.0.1] enable ipsec-policy policy001
[SwitchB-ospfv3-1-area-0.0.0.1] quit
[SwitchB-ospfv3-1] quit
# Configure Switch C.
[SwitchC] ospfv3 1
[SwitchC-ospfv3-1] area 0
[SwitchC-ospfv3-1-area-0.0.0.0] enable ipsec-policy policy002
[SwitchC-ospfv3-1-area-0.0.0.0] quit
[SwitchC-ospfv3-1] quit
Verify the configuration.
5.
OSPFv3 traffic between Switches A, B, and C is protected by IPsec.

Troubleshooting OSPFv3 configuration

No OSPFv3 neighbor relationship established

Symptom
No OSPF neighbor relationship can be established.
Analysis
If the physical link and lower protocol function properly, check OSPF parameters configured on interfaces.
The two neighboring interfaces must have the same parameters, such as the area ID, network segment
and mask, and network type. If the network type is broadcast, at least one interface must have a DR
priority higher than 0.
Process steps
Display neighbor information using the display ospfv3 peer command.
1.
Display OSPFv3 interface information using the display ospfv3 interface command.
2.
Ping the neighbor router's IP address to check connectivity.
3.
Check OSPF timers. The dead interval on an interface must be at least four times the hello interval.
4.
On a broadcast network, at least one interface must have a DR priority higher than 0.
5.
313