Configuring Ripng Route Redistribution - HP 3600 v2 series Configuration Manual

Hide thumbs Also See for 3600 v2 series:
Table of Contents

Advertisement

Configuring RIPng route redistribution

Network requirements
Two RIPng processes are running on Switch B, which communicates with Switch A through RIPng 100
and with Switch C through RIPng 200.
Configure route redistribution on Switch B, letting the two RIPng processes redistribute routes from each
other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 104 Network diagram
Configuration procedure
Configure IPv6 addresses for the interfaces. (Details not shown)
1.
Configure RIPng basic functions.
2.
# Enable RIPng 100 on Switch A.
<SwitchA> system-view
[SwitchA] ripng 100
[SwitchA-ripng-100] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 100 enable
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] ripng 100 enable
[SwitchA-Vlan-interface200] quit
# Enable RIP 100 and RIP 200 on Switch B.
<SwitchB> system-view
[SwitchB] ripng 100
[SwitchB-ripng-100] quit
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] ripng 100 enable
[SwitchB-Vlan-interface100] quit
[SwitchB] ripng 200
[SwitchB-ripng-200] quit
[SwitchB] interface vlan-interface 300
[SwitchB-Vlan-interface300] ripng 200 enable
[SwitchB-Vlan-interface300] quit
# Enable RIPng 200 on Switch C.
<SwitchC> system-view
[SwitchC] ripng 200
[SwitchC] interface vlan-interface 300
[SwitchC-Vlan-interface300] ripng 200 enable
275

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents