HP 3600 v2 series Configuration Manual page 143

IS-IS address format
NSAP
1.
As shown in
Specific Part (DSP). The IDP is equal to the network ID of an IP address, and the DSP is equal to the subnet
and host ID.
The IDP includes the Authority and Format Identifier (AFI) and the Initial Domain Identifier (IDI).
The DSP includes the High Order Part of DSP (HO-DSP), System ID, and SEL, where the HO-DSP identifies
the area, the System ID identifies the host, and the SEL identifies the type of service.
The IDP and DSP are variable in length. The length of an NSAP address varies from 8 bytes to 20 bytes.
Figure 49 NSAP address format
Area address
2.
The area address comprises the IDP and the HO-DSP of the DSP, which identify the area and the routing
domain. Different routing domains cannot have the same area address.
Typically, a router only needs one area address, and all nodes in the same routing domain must share the
same area address. However, a router can have a maximum of three area addresses to support smooth
area merging, partitioning, and switching.
System ID
3.
A system ID identifies a host or router uniquely. It has a fixed length of 48 bits (6 bytes).
The system ID of a device can be generated from the Router ID. For example, a router uses the IP address
168.10.1.1 of Loopback 0 as the Router ID. The system ID in IS-IS can be obtained in the following ways:
Extend each decimal number of the IP address to 3 digits by adding 0s from the left, like
•
168.010.001.001;
Divide the extended IP address into 3 sections with 4 digits in each section to get the system ID
•
1680.1000.1001.
If you use other methods for defining a system ID, always make sure that it can uniquely identify a host
or router.
SEL
4.
The NSAP Selector (SEL), or the N-SEL, is similar to the protocol identifier in IP. Different transport layer
protocols correspond to different SELs. All SELs in IP are 00.
Routing method
5.
Because the area information is identified in IS-IS addresses, a Level- 1 router can easily identify packets
destined to other areas.
A Level- 1 router makes routing decisions based on the system ID. If the destination is not in the area,
•
the packet is forwarded to the nearest Level- 1 -2 router.
A Level-2 router routes packets across areas according to the area address.
•
Figure 49, an NSAP address consists of the Initial Domain Part (IDP) and the Domain
131