Dynamic Routing Protocols - HP 3600 v2 series Configuration Manual

NOTE:
For more information about the FIB table, see
Routing table information
Display the brief information of a routing table by using the display ip routing-table command.
For example:
<Sysname> display ip routing-table
Routing Tables: Public
Destinations : 7
Destination/Mask
1.1.1.0/24
2.2.2.0/24
80.1.1.0/24
...(Part of the output information is omitted)
A route entry includes the following key items:
• Destination—Destination IP address or destination network
Mask—The network mask specifies, in company with the destination address, the address of the
•
destination network. A logical AND operation between the destination address and the network
mask yields the address of the destination network. For example, if the destination address is
129.102.8.10 and the mask 255.255.0.0, the address of the destination network is 129.102.0.0. A
network mask is made up of a certain number of consecutive 1s. It can be expressed in dotted
decimal format or by the number of the 1s.
• Pre—Preference of the route. Among routes to the same destination, the one with the highest
preference is optimal.
Cost—When multiple routes to a destination have the same preference, the one with the smallest
•
cost becomes the optimal route.
NextHop—Specifies the IP address of the next hop
•
Interface—Specifies the interface through which a matching IP packet is to be forwarded
•

Dynamic routing protocols

Based on dynamic routing protocols, dynamic routing can detect network topology changes and
recalculate the routes, so it is suitable for large networks. However, dynamic routing is difficult to
configure, imposes higher requirements on the system, and consumes a certain amount of network
resources.
Dynamic routing protocols can be classified based on different criteria, as shown in
Table 1 Dynamic routing protocols
Criterion
Optional scope
Layer 3—IP Services Configuration Guide
Routes : 7
Proto Pre Cost
Direct 0 0
Static 60 0
OSPF 10 2
Categories
•
Interior gateway protocols (IGPs)—Work within an autonomous system (AS).
Examples include RIP, OSPF, and IS-IS.
•
Exterior gateway protocols (EGPs)—Work between ASs. The most popular one is
BGP.
2
NextHop Interface
1.1.1.1 Vlan11
12.2.2.2 Vlan12
80.1.1.1 Vlan13
.
Table 1: