HP 3600 v2 series Configuration Manual page 50

Figure 10 Network diagram
Configuration procedure
Configure an IP address for each interface. (Details not shown)
1.
Configure basic RIP functions.
2.
# Configure Switch A.
[SwitchA] rip
[SwitchA-rip-1] network 192.168.1.0
[SwitchA-rip-1] network 172.16.0.0
[SwitchA-rip-1] network 172.17.0.0
# Configure Switch B.
[SwitchB] rip
[SwitchB-rip-1] network 192.168.1.0
[SwitchB-rip-1] network 10.0.0.0
# Display the RIP routing table of Switch A.
[SwitchA] display rip 1 route
Route Flags: R - RIP, T - TRIP
----------------------------------------------------------------------------
Peer 192.168.1.2
Destination/Mask
10.0.0.0/8
The output shows that RIPv1 uses a natural mask.
Configure RIP version.
3.
# Configure RIPv2 on Switch A.
[SwitchA] rip
[SwitchA-rip-1] version 2
[SwitchA-rip-1] undo summary
# Configure RIPv2 on Switch B.
[SwitchB] rip
[SwitchB-rip-1] version 2
[SwitchB-rip-1] undo summary
# Display the RIP routing table on Switch A.
[SwitchA] display rip 1 route
Route Flags: R - RIP, T - TRIP
----------------------------------------------------------------------------
Peer 192.168.1.2
Destination/Mask
P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect
on Vlan-interface100
Nexthop
192.168.1.2
P - Permanent, A - Aging, S - Suppressed, G - Garbage-collect
on Vlan-interface100
Nexthop
Cost Tag Flags
1 0
Cost Tag Flags
38
Sec
RA 11
Sec