Configuring Rip To Advertise A Summary Route - HP 3600 v2 series Configuration Manual

1.1.4.0/24, cost 2, nexthop 1.1.1.2
1.1.5.0/24, cost 2, nexthop 1.1.1.2
The output shows that only one RIP route reaches network 1.1.5.0/24, with the next hop as Switch B
(1.1.1.2) and a cost of 2.

Configuring RIP to advertise a summary route

Network requirements
In the following figure, Switch A and Switch B run OSPF, Switch D runs RIP, and Switch C runs OSPF and
RIP.
Configure RIP to redistribute OSPF routes on Switch C so that Switch D has routes destined for networks
10.1.1.0/24, 10.2.1.0/24, 10.5.1.0/24, and 10.6.1.0/24.
Configure route summarization on Switch C and advertise only the summary route 10.0.0.0/8, reducing
the routing table size of Switch D.
Figure 13 Network diagram
Configuration procedure
Configure IP addresses for interfaces. (Details not shown)
1.
Configure OSPF basic functions.
2.
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.5.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 10.2.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ospf
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 10.6.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] quit
# Configure Switch C.
43