Configuring Local Pbr; Configuring Interface Pbr - HP 3600 v2 series Configuration Manual

NOTE:
If a policy has a node with no if-match clause configured, all packets can pass the policy node.
•
However, an action is taken according to the match mode, and the packets will not go to the next policy
node for a match.
If a policy has a node with the permit match mode but no apply clause configured, all packets matching
•
all the if-match clauses can pass the policy node. However, no action is taken, the packets will not go to
the next policy node for a match, and will be forwarded according to the routing table.
• If a policy has a node with no if-match or apply clauses configured, all packets can pass the policy
node. However, no action is taken; the packets will not go to the next policy node for a match, and will
be forwarded according to the routing table.

Configuring local PBR

Only one policy can be referenced for local PBR.
Follow these steps to configure local PBR:
To do...
Enter system view
Configure local PBR based on a
policy
NOTE:
If the specified policy does not exist, the local PBR configuration succeeds, but it takes effect only when the
policy is created.

Configuring interface PBR

Only one policy can be referenced by an interface for interface PBR.
Follow these steps to configure interface PBR:
To do...
Enter system view
Enter interface view
Configure interface PBR based on
a policy
NOTE:
If the specified policy does not exist, the interface PBR configuration succeeds, but it takes effect only when
the policy is created.
Use the command...
system-view
ip local policy-based-route
policy-name
Use the command...
system-view
interface interface-type
interface-number
ip policy-based-route policy-name
381
Remarks
—
Required
Not configured by default.
Remarks
—
—
Required
Not configured by default.