HP 3600 v2 series Configuration Manual page 30

[SwitchA] interface loopback 1
[SwitchA-LoopBack1] bfd min-transmit-interval 500
[SwitchA-LoopBack1] bfd min-receive-interval 500
[SwitchA-LoopBack1] bfd detect-multiplier 9
[SwitchA-LoopBack1] quit
[SwitchA] ip route-static 120.1.1.0 24 2.2.2.9 bfd control-packet bfd-source 1.1.1.9
[SwitchA] ip route-static 120.1.1.0 24 vlan-interface 11 10.1.1.100 preference 65
[SwitchA] quit
# Configure static routes on Switch B and enable BFD control packet mode for the static route through
Switch D.
<SwitchB> system-view
[SwitchB] interface loopback 1
[SwitchB-LoopBack1] bfd min-transmit-interval 500
[SwitchB-LoopBack1] bfd min-receive-interval 500
[SwitchB-LoopBack1] bfd detect-multiplier 9
[SwitchB-LoopBack1] quit
[SwitchB] ip route-static 121.1.1.0 24 1.1.1.9 bfd control-packet bfd-source 2.2.2.9
[SwitchB] ip route-static 121.1.1.0 24 vlan-interface 13 13.1.1.2 preference 65
[SwitchB] quit
# Configure static routes on Switch C.
<SwitchC> system-view
[SwitchC] ip route-static 120.1.1.0 24 vlan-interface 13 13.1.1.1
[SwitchC] ip route-static 121.1.1.0 24 vlan-interface 11 10.1.1.102
# Configure static routes on Switch D.
<SwitchD> system-view
[SwitchD] ip route-static 120.1.1.0 24 vlan-interface 12 11.1.1.1
[SwitchD] ip route-static 121.1.1.0 24 vlan-interface 10 12.1.1.1
Verify the configuration.
3.
The following operations are performed on Switch A. The operations on Switch B are similar and not
shown.
# Display the BFD session information of Switch A.
<SwitchA> display bfd session
Total Session Num: 1
Session Working Under Ctrl Mode:
LD/RD SourceAddr
4/7 1.1.1.9
# Display the static route information of Switch A.
<SwitchA> display ip routing-table protocol static
Public Routing Table : Static
Summary Count : 2
Static Routing table Status : < Active>
Summary Count : 1
Init Mode: Active
DestAddr State Holdtime Interface
2.2.2.9 Up
18
2000ms Loop1