Configuring The Wireless Aps For The First Time - Siemens HiPath C10 User Manual

Left LED Center LED
Status Status
Green when Green
802.11b/g
enabled
Off
otherwise
Off Red/Green
Table 5 Wireless AP LED status
Random delays do not occur during normal reboot. A random delay only occurs after
>
vulnerable period power-down.
The wireless AP can be reset to its factory default settings. For more information,
see Section 12.2, "Resetting the AP to its factory default settings", on page 246.
5.3

Configuring the wireless APs for the first time

Before the wireless AP is configured for the first time, you must first confirm that the following
has already occurred:
The HiPath Wireless Controller has been set up. For more information, see Chapter 4,
●
"Configuring the HiPath Wireless Controller".
The Controller, Access Points and Convergence Software has been configured. For more
●
information, see Chapter 4, "Configuring the HiPath Wireless Controller".
The wireless APs have been installed. For more information, see the HiPath Wireless
●
Controller, Access Points and Convergence Software AP Installation Instructions.
Once the above processes are complete, you can then continue with the wireless AP initial
configuration. The wireless AP initial configuration involves two steps:
Step One – Define parameters for the discovery process. For more information, see
●
Section 5.3.1, "Defining properties for the discovery process", on page 77.
Step Two – Connect the wireless AP to a power source to initiate the discovery and
●
registration process. For more information, see Section 5.3.2, "Connecting the Wireless AP
to a power source and initiating the discovery and registration process", on page 80.
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
Configuring the wireless APs for the first time
Right LED
Status
Green when 802.11a
enabled
Off otherwise
Off
Configuring the wireless AP
AP Status
Radios enabled per user settings
Upgrading firmware.
hwc_apstartup.fm
75