Resetting Wireless APs to Factory Default Settings
You can set a wireless AP to its factory default settings by pressing and holding the reset button for
approximately six seconds.
Note
If you press the reset button and do not hold it longer than six seconds, the wireless AP will merely
reboot, and not reset to its factory defaults.
Refer to the installation documentation for your model for the location of the reset button. Copies of
the AP installation documentation are available
%26support
Notice
The restoration of factory default settings does not erase the non-volatile log.
SCALANCE WLC711 Maintenance Guide
Performing System Maintenance
Resetting Wireless APs to Factory Default Settings
at:http://www.siemens.com/automation/service
53