Configuring The Default Ap Settings - Siemens HiPath C10 User Manual

C10/c100/c1000 ap26 series wireless controller, access points and convergence software, v4.0
Hide thumbs Also See for HiPath C10:
Table of Contents

Advertisement

3.
To select the wireless APs for status change, do one of the following:
For a specific Wireless AP, select the corresponding checkbox.
For Wireless AP's by category, click one of the Select Wireless APs buttons.
To deselect your Wireless AP selections, click Clear All.
4.
Click the appropriate Perform action on selected Wireless APs option:
Approved – Change a Wireless AP's status from Pending to Approved, if the AP
Registration screen was set to register only approved Wireless APs.
Approved as Sensor –
Pending – AP is removed from active list, and is forced into discovery.
Release – Release foreign Wireless APs after recovery from a failover.
Delete – Delete this Wireless AP from the VNS.
5.5.2

Configuring the default AP settings

Wireless APs are added with default settings. You can modify the system's AP default settings
accordingly, and then use these default settings to configure newly added APs. In addition, you
can base the system's AP default settings on an existing AP configuration or have configured
APs inherit the properties of the default AP configuration when they register with the system.
To configure the default AP settings:
1.
From the main menu, click Wireless AP Configuration. The HiPath Wireless AP screen
appears.
2.
In the left pane, click AP Default Settings.
3.
Modify the following AP default settings as required:
AP Properties
Radio Settings
Static Configuration
Dynamic Radio Management
VNS Assignments
4.
In the AP Properties section, modify the following:
Poll Timeout * Interval – Type the timeout and interval values, in seconds, for polling
the controller. The default values are 10 seconds and 2 seconds, respectively.
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
<<<need description>>>
hwc_apstartup.fm
Configuring the wireless AP
Modifying wireless AP settings
83

Advertisement

Table of Contents
loading

Table of Contents