Siemens HiPath C10 User Manual page 248

hwc_ongoing.fm
Performing system maintenance
Performing system maintenance tasks
To set a poll interval:
1. From the main menu, click Wireless Controller Configuration. The Wireless Controller
Configuration screen appears.
2. From the left pane, click System Maintenance. The System Maintenance screen
appears.
3. In the Health Checking area, in the Poll Timer box, type the time interval (in seconds) for
the HiPath Wireless Controller to check that each Wireless AP is connected. The default is
60 seconds.
4. Click Apply.
To enable and define parameters for Syslog:
1. From the main menu, click Wireless Controller Configuration. The Wireless Controller
Configuration screen appears.
2. From the left pane, click System Maintenance. The System Maintenance screen
appears.
3. In the Syslog area, to enable the Syslog function for up to three syslog servers, select the
appropriate checkboxes.
4. For each enabled syslog server, in the IP box, type a valid IP address for the server on the
network.
5. For each enabled syslog server, in the Port # box, type a valid port number to connect on.
The default port for syslog is 514.
6. To include all system messages, select the Include all service messages checkbox. If the
box is not selected, only component messages (logs and traces) are relayed. This setting
applies all three servers. The additional service messages are:
DHCP messages reporting users receiving IP addresses
●
Startup Manager Task messages reporting component startup and failure
●
7. To include audit messages, select the Include audit messages checkbox.
8. From the Application Logs drop-down list, select the log level (local.0 - local.6) to be sent
to the syslog server. This setting applies all three servers.
9. If the Include all service messages checkbox is selected, the Service Logs drop-down
list becomes selectable. Select the log level (local.0 - local.6) to be sent to the syslog
server. This setting applies all three servers.
10. If you selected the Include audit messages checkbox, the Audit Logs drop-down list
becomes available. Select the log level (local.0 - local.6) to be sent to the syslog server.
This setting applies all three servers.
248
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
A31003-W1040-U101-1-7619, July 2006 DRAFT