5.
For each filtering rule you are defining, do the following:
In the IP/subnet:port box, type the destination IP address. You can also specify an IP
●
range, a port designation, or a port range on that IP address.
In the Protocol drop-down list, select the applicable protocol. The default is N/A.
●
6.
Define a rule to allow access to the default gateway for this VNS:
Select IP/Port.
●
Type the default gateway IP address (VNS' IP address) that you defined in the
●
Topology tab for this VNS.
7.
Click Add. The information appears in the Filter Rules area of the tab.
8.
Select the new filter, then select the Allow checkbox applicable to the rule you defined.
9.
Edit the order of a filter by selecting the filter and clicking the Up and Down buttons. The
filtering rules are executed in the order you define here.
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Virtual Network configuration
Configuring filtering rules for a VNS
155