Siemens HiPath C10 User Manual page 60

hwc_startup.fm
Configuring the HiPath Wireless Controller
Performing the first-time setup of the HiPath Wireless Controller
The MTU of the ports on either end of an OSPF link must match. The MTU for ports on the
●
HiPath Wireless Controller is defined as 1500, in the IP Addresses screen, during data port
setup. This matches the default MTU in standard routers.
To set OSPF Routing Global Settings on the HiPath Wireless Controller:
1. From the main menu, click Wireless Controller Configuration. The HiPath Wireless
Controller Configuration screen appears.
2. In the left pane, click Routing Protocols. The Static Routes tab appears.
3. Click the OSPF tab.
4. From the OSPF Status drop-down list, select ON to enable OSPF.
5. In the Router ID box, type the IP address of the HiPath Wireless Controller. This ID must
be unique across the OSPF area. If left blank, the OSPF daemon automatically picks a
router ID from one of the HiPath Wireless Controller's interface IP addresses.
6. In the Area ID box, type the area. 0.0.0.0 is the main area in OSPF.
7. From the Area Type drop-down list, select one of the following:
60
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
A31003-W1040-U101-1-7619, July 2006 DRAFT