Siemens HiPath C10 User Manual page 85

Basic Rates – Select the data rates that must be supported by all stations in a BSS:
●
1, 2 or 1, 2, 5.5, and 11 Mbps.
Preamble – Select a preamble value: Short, Long, or Auto.
●
Protection Mode – Select a protection mode: None, Auto, or Always. The default
●
value is Auto.
Protection Rate – Select a protection rate: 1, 2, 5.5, or 11 Mbps. The default value is
●
11.
Protection Type – Select a protection type: CTS or RTS CTS. The default value is
●
RTS CTS.
Min Basic Rate – For both radios, select the minimum data rate that must be
●
supported by all stations in a BSS: 1, 2, 5.5, or 11 Mbps.
Max Basic Rate – For both radios, select the maximum data rate that must be
●
supported by all stations in a BSS: 1, 2, 5.5, or 11 Mbps.
Max Operational Rate – For both radios, select the maximum data rate that clients
●
can operate at while associated with the AP: 11, 12, 18, 24, 36, 48, or 54 Mbps.
6. In the Static Configuration section, modify the following:
In the Add box, type the IP address of the HiPath Wireless Controller that will control
●
this Wireless AP.
Click Add. The IP address is added to the list.
●
Repeat to add additional HiPath Wireless Controllers.
●
Click Up and Down to modify the order of the controllers. The maximum is three
●
controllers.
The Wireless AP attempts to connect to the IP addresses in the order in which they
are listed. The Wireless AP is successful when it finds a HiPath Wireless Controller
that will allow it to register.
This feature allows the Wireless AP to bypass the discovery process. If the Wireless
Controller Search List box is not populated, the wireless AP will use SLP to discover
a HiPath Wireless Controller.
The DHCP function for wireless clients must be provided locally by a local DHCP
server, unless each wireless client has a static IP address.
7. In the Dynamic Radio Management section, modify the following:
Enable – Select Enable or Disable. DRM is enabled by default.
●
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_apstartup.fm
Configuring the wireless AP
Modifying wireless AP settings
85