Siemens HiPath C10 User Manual page 58

hwc_startup.fm
Configuring the HiPath Wireless Controller
Performing the first-time setup of the HiPath Wireless Controller
5. In the Gateway box, type the IP address of the specific router port or gateway on the same
subnet as the HiPath Wireless Controller to which to forward these packets. This is the IP
address of the next hop between the HiPath Wireless Controller and the packet's ultimate
destination.
6. Click Add. The new route is added to the list of routes.
7. Select the Override dynamic routes checkbox to give priority over the OSPF learned
routes, including the default route, which the HiPath Wireless Controller uses for routing.
This option is selected by default.
To remove this priority for static routes, so that routing is controlled dynamically at all times,
clear the Override dynamic routes checkbox.
If you enable dynamic routing (OSPF), the dynamic routes will normally have
>
priority for outgoing routing. For internal routing on the HiPath Wireless
Controller, the static routes normally have priority.
8. To save your changes, click Save.
To view the forwarding table on the HiPath Wireless Controller:
1. From the main menu, click Reports & Displays. The HiPath Reports & Displays screen
appears.
2. To view the static routes that have been defined for the HiPath Wireless Controller, click
Forwarding Table. The Forwarding Table appears.
58
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
A31003-W1040-U101-1-7619, July 2006 DRAFT