Siemens HiPath C10 User Manual page 187

The VLAN IDs are assigned by the branch office network administrator. The AP
>
will operate correctly only if the VLAN ID is unique per AP and there is at most
one untagged VNS per AP.
6. To save your changes, click Save.
In previous releases, an entire AP had to be put into branch mode. In the current
>
release, an individual VNS can be put into bridging mode. An AP can have bridged
and non-bridged VNSs.
If it has more then one branch mode VNS, only one bridged VNS can be untagged
per AP. The other branch mode VNSs need to have unique VLAN ID. You must have
VLAN aware L2 switches to support this feature.
When a VNS is setup for bridged mode, it cannot be switched to tunneled mode. The
>
administrator must delete and re-add the VNS.
A31003-W1040-U101-1-7619, July 2006 DRAFT
HiPath Wireless Controller, Access Points and Convergence Software V4.0, C10/C100/C1000 User Guide
hwc_vnsconfiguration.fm
Virtual Network configuration
Bridging traffic locally
187