Redundant Power Supply Enablement Option; Installing The Redundant Power Supply Enablement Kit - HPE ProLiant DL160 Gen10 User Manual

Redundant power supply enablement option

The RPS enablement option supports the installation of two Gen10 Flexible Slot (Flex Slot) power supplies.
Adding a second power supply provides redundant power support to the server if one power supply fails. You do not have
to power down the server before removing or installing a redundant hot-plug power supply.
Kit contents
• Redundant power supply cage
• Power distribution board

Installing the redundant power supply enablement kit

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• The components included with the hardware option kit
• T-15 Torx screwdriver
• T-10 Torx screwdriver
• Hot-plug power supply
Procedure
1.
Back up all server data.
2. If installed, remove the bezel.
3. Power down the server.
4. Access the product rear panel.
5.
Release the power cord from the strain relief clip.
6.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
7. Remove the server from the rack.
8. Place the server on a sturdy, level surface.
9. Remove the access panel.
10. Remove the rail.
a. Extend the rail.
Hardware options installation 47