Wan Interface Configuration Commands; Common Wan Interface Configuration Commands; Bandwidth - HP MSR series Command Reference Manual

WAN interface configuration commands

The following matrix shows the hardware and interface compatibility:
Hardware
CE3 and CT3 interface modules
MSR900 series
MSR93X series

Common WAN interface configuration commands

bandwidth

Use bandwidth to set the expected bandwidth for the interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
Serial interface view, AUX interface view, AM interface view, Cellular interface view, E1-F interface view,
T1-F interface view, ISDN BRI interface view, CE3 interface view, CT3 interface view, CE1/PRI interface
view, CT1/PRI interface view
Default command level
2: System level
Parameters
bandwidth-value: Expected bandwidth for the interface, in the range of 1 to 4294967295 kbps.
Usage guidelines
You can obtain the expected bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
Support for interfaces
The modules do not support subrate configuration if the module
hardware version is earlier than Hardware 2.2.
Supports only the AUX and USB 3G/4G modem interfaces.
The JG514A, JG514B, JG515A, JG515B, JG531A and JG531B
support serial interfaces.
The JG516A, JG516B, JG517A and JG517B support G.SHDSL
interfaces.
The JG518A, JG518B, JG519A, JG519B, JH013A, JG520A,
JG520B, JG597A and JG597B support ADSL2+ interfaces.
The JG513A, JG513B, JG515A, JG515B, JG531A, JG531B,
JG517A, JG517B, JG520A, JG520B, JG596A and JG665A support
3G/4G modem interfaces.
JG597A and JG597B support ISDN BRI interfaces.
44