HP MSR series Command Reference Manual page 196

BERT state:(stopped)
Table 25 Command output
Field
E3 10/0 current state: UP
Description : E3 10/0 Interface
Current mode is CE3, loopback not set
Alarm: none
ERROR: 2 BPV, 0 EXZ, 0 FrmErr, 0 FEBE
BERT state:(completed)
Test pattern: 2^7, Status: Not Sync, Sync Detected: 0
Time: 2 minute(s), Time past: 2 minute(s)
Bit errors (since test started): 0 bits
Bits received (since test started): 0 Mbits
Bit errors (since latest sync): 0 bits
Bits received (since latest sync): 0 Mbits
E3 10/0 CE1 1 is up
Frame-format NO-CRC4, clock slave, loopback not set
Receiver alarm state is none
Description
E3 interface state.
E3 interface description.
Operating mode: CE3 or E3.
Loopback mode: payload, remote, local, or no
loopback.
Alarm information: los, ais, rai, or lof.
Statistics on each types of errors.
BERT state:
•
Stopped—The test is stopped by the user
command.
•
running.
•
completed.
Test mode:
•
2^7.
•
2^1 1.
•
2^15.
•
QRSS.
Synchronization state:
•
Not Sync—Not synchronized due to a connection
failure.
•
Sync—Synchronized.
Total test time and past test time
Number of bit errors received since the test has
begun.
Total number of bits received since the test has begun.
Number of bit errors received since the last
synchronization.
Total number of bits received since the last
synchronization.
CE1 channel on the E3 interface.
Information about the E1 line:
•
Framing format—None, 33, or 16.
•
Clock source—Slave for the line clock and master
for the internal clock.
•
Loopback—Local, remote, payload, or not set.
Types of alarms: LOS, LOF, AIS, and RAI.
When the interface receives a LOS, LOF, or AIS and
sends a RAI to the peer, Transmitter is sending RAI is
displayed.
187