Display Dsl Version - HP MSR series Command Reference Manual

Active Params
Standard:
SNR (dB):
Attn(dB):
Pwr(dBm):
Current Rate(kbps):
Latency:
Table 32 Command output
Field
Line Status
Training Status
The following information appears after the line is activated.
Active Params

display dsl version

Use display dsl version to display the DSL version and support capabilities of the specified interface.
Syntax
display dsl version interface atm interface-number [ | { begin | exclude | include } regular-expression ]
Views
Any view
Near End Far End
G.dmt G.dmt
0.0 0.0
0.0 0.0
0.0 0.0
0 0
Intl Intl
Description
Line status of the ADSL interface:
•
No Defect—Normal state.
•
Loss Of Frame—Error concerning frame.
•
Loss Of Signal—Error concerning signal.
•
Loss Of Power—Error concerning power supply.
•
Loss Of Signal Quality—Error concerning signal quality.
•
Unknown—Unknown error.
Training status of the ADSL interface:
•
Idle—The interface is idle.
•
G.994 Training—A G.994 training.
•
G.992 Started—A G.992 training is launched.
•
G.922 Channel Analysis—G.922 channel analysis is going on.
•
G.992 Message Exchange—G.992 message exchange is
going on.
•
Showtime—Normal data exchange.
•
Unknown..
•
Standard—Connection standard adopted by the interface and
the DSLAM.
•
SNR—Signal-to-noise ration of the ADSL link.
•
Attr—Attenuation of the ADSL link.
•
Pwr—Transmit power of the ADSL module, in dbm.
•
Current Rate—Uplink/downlink rate between the ADSL
interface and the DSLAM, in kbps.
•
Latency—Way in which the interface and the DSLAM are
connected, which can be "Intl" (cross-over) and "Fast."
262