HP MSR series Command Reference Manual page 308

Frame-format: ESF,
CT1 84 is down
Frame-format: ESF,
Table 39 Command output
Field
Cpos4/0 current state:
Description:
Frame-format SDH, multiplex AU-3,
clock master, loopback none
SD threshold: 6 , SF threshold: 3
Optical
Regenerator section:
Tx: J0
Rx: J0
Alarm:
Error:
Multiplex section:
Higher order path(VC-4-1):
CT1 1 is down
Frame-format: ESF, clock: slave,
loopback: none
Related commands
display controller cpos e1
•
• display controller cpos t1
display controller cpos e1
Use display controller cpos e1 to display the physical layer configuration information of an E1 channel
on a CPOS interface.
Syntax
display controller cpos cpos-number e1 e1-number [ | { begin | exclude | include } regular-expression ]
Views
Any view
clock: slave, loopback: none
clock: slave, loopback: none
Description
Current physical state of the CPOS interface.
Interface description.
Physical layer information of the CPOS interface: the framing format
is set to SDH, AU-3 path is adopted, master clock (internal clock
signal) is used, and loopback is disabled.
SD threshold and SF threshold of the CPOS interface.
Transmission medium.
Alarm and error statistics about the regenerator section.
Sent overhead bytes.
Received overhead bytes.
Alarm statistics.
Error statistics.
Alarm and error statistics about the multiplex section.
Alarm and error statistics about the higher-order path. VC-4-1
indicates the AU-4 path is adopted. In the AU-4 path, there is one
higher-order path VC-4. The x in "VC-3-x" indicates the path
number. When adopting AU-3 path, one STM-1 has three
higher-order paths because it is multiplexed by three VC-3s.
Current physical state of T1 channel 1 of the CPOS interface 4/0.
Physical layer information of T1 channels: the framing format is set
to ESF, master clock (internal clock signal) is used, and loopback is
disabled.
299