Display Ft1 - HP MSR series Command Reference Manual

Default
The CRC mode for a synchronous serial interface formed on a CT1/PRI interface is 16-bit CRC.
Views
Synchronous serial interface view
Default command level
2: System level
Parameters
16: Adopts 16-bit CRC.
32: Adopts 32-bit CRC.
none: Disables CRC.
Examples
# Adopt 32-bit CRC on T1-F interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] crc 32

display ft1

Use display ft1 to display the configuration and state information about a T1-F interface.
Syntax
display ft1 [ serial interface-number ] [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
serial interface-number: Specifies a serial interface by its number. If no interface is specified, this
command displays the information about all the T1-F interfaces.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Usage guidelines
If the specified interface is a common serial interface rather than a T1-F interface, the system will display
the prompt.
Examples
# Display information about T1-F interface Serial 2/0.
167