HP MSR series Command Reference Manual page 295

# Display brief information about POS 8/0.
<Sysname> display interface pos 8/0 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Pos8/0
# Display brief information about all POS interfaces in DOWN state.
<Sysname> display interface pos brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
Pos8/0
# Display brief information about POS interfaces, including their complete interface descriptions.
<Sysname> display interface pos brief description
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Pos8/0
Pos8/1
Table 37 Command output
Field
current state
Line protocol current state
Description
The Maximum Transmit Unit is 1500, Hold timer is
10(sec)
Internet protocol processing
Link layer protocol is PPP
LCP opened, IPCP opened, IP6CP opened
Physical layer is Pos1/0, Baudrate is 155520000
bit/s
Scramble enabled, crc 32, clock slave, loopback not
set
Link Protocol Main IP
UP UP(s) --
Link Cause
ADM Administratively
Link Protocol Main IP
UP UP(s) --
DOWN DOWN(s) --
286
Description
Description
The interface for connecting RouterD.
--
Description
Current state of the POS interface:
•
DOWN (Administratively)—The POS interface has
been shut down with the shutdown command.
•
DOWN—The POS interface is physically down
because no physical link is present or the link has
failed.
•
UP—The POS interface is both administratively
and physically up.
Link layer state of the POS interface.
Description on the POS interface.
MTU of the POS interface and the interval at which the
link layer protocol sends keepalives.
IP protocol processing capability, enabled or
disabled.
Link layer protocol of the POS interface and loopback
detection state.
LCP state, IPCP state, and IPv6CP state.
Physical interface and baudrate.
Payload scrambling state, CRC count, clock mode,
and loopback state on the interface.