Shdsl Annex - HP MSR series Command Reference Manual

ATM SAR Device:
ATM SAR Revision:
Chipset Vendor:
Firmware Rel-Rev:
DSP Version:
PCB Version:
CPLD Version:
Driver Version:
Hardware Version:
ITU G991.2 ANNEX A:
ITU G991.2 ANNEX B:
Table 36 Command output
Field
Dsl line Type
ATM SAR Device
ATM SAR Revision
Chipset Vendor
Firmware Rel-Rev
CPLD Version
Driver Version
ITU G991.2 ANNEX A, ITU G991.2 ANNEX B

shdsl annex

Use shdsl annex to set the annex standard to be adopted by a G.SHDSL interface. You cannot activate
a link with different standard types at its two ends.
Use undo shdsl annex to restore the default.
Syntax
shdsl annex { a | b }
undo shdsl annex
Default
The annex standard is Annex B.
Views
ATM (G.SHDSL) interface view
Default command level
2: System level
Parameters
a: Specifies Annex A standard.
b: Specifies Annex B standard.
0x823614f1
0x02
GSPN
R2.3.1-0
1
0.0
0.0
2.0
1.0
Supported
Supported
271
Description
Type of the user access line.
Identifier of the SAR chip.
Revision identifier of the SAR chip.
Identifier of the DSL chipset vendor.
Identifier and version of the firmware.
Logic version.
Driver software version.
Standards and the annexes supported by the
interface.