Xilinx HDMI 1.4 Product Manual page 75

Choose Low in Example Design (according to board design).
• HDCP 1.4/2.2 is enabled by default in Example Design application software.
Removed UART option to Enable HDCP 1.4 or HDCP 2.2.
• Auto switching has been added to the Example Design Application software.
You do not need to choose HDCP 1.4 or HDCP 2.2 from UART. A corresponding HDCP is
selected according to the capability of connected source/sink. If the device support
both HDCP 1.4 and HDCP 2.2, the priority is given to HDCP 2.2.
• HDCP repeater feature has been added.
You can enabled/disable it by selecting "h" from UART menu.
• System log is moved from direct UART printout to event log.
You can display the event log by selecting "z" from UART menu.
HDMI 1.4/2.0 TX Subsystem
PG235 October 4, 2017 www.xilinx.com
Chapter 5: Example Design
Send Feedback
75