AudioCodes Mediant 800B User Manual page 768

Parameter
[NoAudioPayloadType]
Web: SIP Transport Type
EMS: Transport Type
CLI: app-sip-transport-type
[SIPTransportType]
Web: SIP UDP Local Port
EMS: Local SIP Port
CLI: sip-udp-local-port
[LocalSIPPort]
Web: SIP TCP Local Port
EMS: TCP Local SIP Port
CLI: sip-tcp-local-port
[TCPLocalSIPPort]
Web: SIP TLS Local Port
EMS: TLS Local SIP Port
CLI: sip-tls-local-port
[TLSLocalSIPPort]
Web/EMS: Enable SIPS
CLI: enable-sips
[EnableSIPS]
Web/EMS: Enable TCP
Connection Reuse
CLI: tcp-conn-reuse
[EnableTCPConnectionRe
use]
Web: Fake TCP alias
User's Manual
relay; otherwise, the fax fails.
Defines the payload type of the outgoing SDP offer.
The valid value range is 96 to 127 (dynamic payload type). The default
is 0 (i.e. NoAudio is not supported). For example, if set to 120, the
following is added to the INVITE SDP:
a=rtpmap:120 NoAudio/8000\r\n
Note: For incoming SDP offers, NoAudio is always supported.
Determines the default transport layer for outgoing SIP calls initiated
by the device.

[0] UDP (default)

[1] TCP

[2] TLS (SIPS)
Notes:

It's recommended to use TLS for communication with a SIP Proxy
and not for direct device-to-device communication.

For received calls (i.e., incoming), the device accepts all these
protocols.

The value of this parameter is also used by the SAS application as
the default transport layer for outgoing SIP calls.
Defines the local UDP port for SIP messages.
The valid range is 1 to 65534. The default is 5060.
Defines the local TCP port for SIP messages.
The valid range is 1 to 65535. The default is 5060.
Defines the local TLS port for SIP messages.
The valid range is 1 to 65535. The default is 5061.
Note: The value of this parameter must be different from the value of
the parameter TCPLocalSIPPort.
Enables secured SIP (SIPS URI) connections over multiple hops.

[0] Disable (default)

[1] Enable
When the SIPTransportType parameter is set to 2 (i.e., TLS) and the
parameter EnableSIPS is disabled, TLS is used for the next network
hop only. When the parameter SIPTransportType is set to 2 or 1 (i.e.,
TCP or TLS) and EnableSIPS is enabled, TLS is used through the
entire connection (over multiple hops).
Note: If this parameter is enabled and the parameter
SIPTransportType is set to 0 (i.e., UDP), the connection fails.
Enables the reuse of the same TCP connection for all calls to the
same destination.

[0] Disable = Uses a separate TCP connection for each call.

[1] Enable = (Default) Uses the same TCP connection for all calls.
Note: For the SAS application, this feature is configured using the
SASConnectionReuse parameter.
Enables the re-use of the same TCP/TLS connection for sessions with
768
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10278