AudioCodes Mediant 800B User Manual page 294

Parameter
Generate SRTP keys mode
CLI: generate-srtp-keys
[IpProfile_GenerateSRTPKeys]
Jitter Buffer Max Delay
CLI: jitter-buffer-max-delay
[IpProfile_JitterBufMaxDelay]
GW
Web: Coders Group ID
CLI: coders-group-id
[IpProfile_CodersGroupID]
Web: Fax Signaling Method
CLI: fax-sig-method
[IpProfile_IsFaxUsed]
User's Manual
Notes:

If this feature is disabled and the server resets the ROC
upon a re-key generation, one-way voice may occur.

The corresponding global parameter is
ResetSRTPStateUponRekey.
Enables the device to generate a new SRTP key upon
receipt of a re-INVITE with this SIP entity.

[0] Only If Required= (Default) The device generates an
SRTP key only if necessary.

[1] Always = The device always generates a new SRTP
key.
Defines the maximum delay and length (in msec) of the Jitter
Buffer.
The valid range is 150 to 2,000. The default is 250.
Defines coders supported by this SIP entity, by assigning a
Coders Group.
The value, Default Coders Group represents the coders
configured in the Coders table (see Configuring Coders on
page 281). All other optional values (e.g., Coders Group 1),
represent the coders defined for the specific Coder Group
configured in the Coder Group Settings table (see
Configuring Coder Groups on page 284).
Defines the SIP signaling method for establishing and
transmitting a fax session when the device detects a fax.

[0] No Fax = (Default) No fax negotiation using SIP
signaling. The fax transport method is according to the
FaxTransportMode parameter.

[1] T.38 Relay = Initiates T.38 fax relay.

[2] G.711 Transport = Initiates fax/modem using the
coder G.711 A-law/Mu-law with adaptations (see Note
below).

[3] Fax Fallback = Initiates T.38 fax relay. If the T.38
negotiation fails, the device re-initiates a fax session
using the coder G.711 A-law/ -law with adaptations (see
the Note below).
Notes:

Fax adaptations (for options 2 and 3):

Echo Canceller = On

Silence Compression = Off

Echo Canceller Non-Linear Processor Mode = Off

Dynamic Jitter Buffer Minimum Delay = 40

Dynamic Jitter Buffer Optimization Factor = 13

If the device initiates a fax session using G.711 (option 2
or 3), a 'gpmd' attribute is added to the SDP in the
following format:

For A-law: 'a=gpmd:8 vbd=yes;ecan=on'

For Mu-law: 'a=gpmd:0 vbd=yes;ecan=on'

When this parameter is set to 1, 2, or 3, the parameter
FaxTransportMode is ignored.

When this parameter is set to 0, T.38 might still be used
294
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10278