AudioCodes Mediant 800B User Manual page 356

Notes:
•
If the device copies the received destination number to the outgoing SIP redirect
number (enabled by the CopyDest2RedirectNumber parameter), no redirect
number Tel-to-IP manipulation is done.
•
The manipulation rules are done in the following order: Stripped Digits From Left,
Stripped Digits From Right, Number of Digits to Leave, Prefix to Add, and then
Suffix to Add.
•
The device uses the 'Redirect Prefix' parameter before it manipulates the prefixi.
The following procedure describes how to configure redirect number manipulation rules in
the Web interface. You can also configure these rules using the following management
tools:

Redirect Number IP to Tel table: ini file parameter, RedirectNumberMapIp2Tel or CLI
command, configure voip/gw manipulations redirect-number-map-ip2tel

Redirect Number Tel to IP table: ini file parameter, RedirectNumberMapTel2Ip or CLI
command, configure voip/gw manipulations redirect-number-map-tel2ip (CLI)

To configure a redirect number manipulation rule:
1. Open the redirect number manipulation table (Configuration tab > VoIP menu > GW
and IP to IP > Manipulations > Redirect Number Tel > IP or Redirect Number IP >
Tel).
2. Click Add; the following dialog box appears (e.g., Redirect Number Tel-to-IP table):
Figure 23-4: Redirect Number Manipulation (e.g., Tel to IP)
3. Configure a manipulation rule according to the parameters described in the table
below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 23-4: Redirect Number Manipulation Tables Parameter Description
Parameter
Index
[_Index]
Manipulation Name
CLI: manipulation-name
[_ManipulationName]
Matching Characteristics - Rule
User's Manual
Defines an index number for the new table record.
Defines an arbitrary name to easily identify the manipulation rule.
The valid value is a string of up to 20 characters.
356
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10278