Snmp Parameters - AudioCodes Mediant 800B User Manual

Parameter

54.1.5 SNMP Parameters

The SNMP parameters are described in the table below.
Parameter
Web: Enable SNMP
CLI: disable
[DisableSNMP]
CLI: port
[SNMPPort]
[ChassisPhysicalAlias]
[ChassisPhysicalAssetID]
[ifAlias]
EMS: Keep Alive Trap Port
[KeepAliveTrapPort]
[SendKeepAliveTrap]
CLI: sys-oid
[SNMPSysOid]
[SNMPTrapEnterpriseOid]
User's Manual
password> (e.g., $1$S3p+fno=).

[1] Enable = All passwords are hidden and replaced by an asterisk
(*).
Table 54-5: SNMP Parameters
Enables SNMP.

[0] Enable (default)

[1] Disable = SNMP is disabled and no traps are sent.
Defines the device's local (LAN) UDP port used for SNMP
Get/Set commands.
The range is 100 to 3999. The default port is 161.
Note: For this parameter to take effect, a device reset is
required.
Defines the 'alias' name object for the physical entity as
specified by a network manager, and provides a non-volatile
'handle' for the physical entity.
The valid range is a string of up to 255 characters.
Defines the user-assigned asset tracking identifier object for the
device's chassis as specified by an EMS, and provides non-
volatile storage of this information.
The valid range is a string of up to 255 characters.
Defines the textual name of the interface. The value is equal to
the ifAlias SNMP MIB object.
The valid range is a string of up to 64 characters.
Defines the port to which keep-alive traps are sent.
The valid range is 0 - 65534. The default is port 162.
Enables keep-alive traps and sends them every 9/10 of the time
as defined by the NATBindingDefaultTimeout parameter.

[0] = Disable

[1] = Enable
Note: For this parameter to take effect, a device reset is
required.
Defines the base product system OID.
The default is eSNMP_AC_PRODUCT_BASE_OID_D.
Note: For this parameter to take effect, a device reset is
required.
Defines the Trap Enterprise OID.
The default is eSNMP_AC_ENTERPRISE_OID.
The inner shift of the trap in the AcTrap subtree is added to the
end of the OID in this parameter.
Note: For this parameter to take effect, a device reset is
712
Mediant 800B Gateway and E-SBC
Description
Description
Document #: LTRT-10278