AudioCodes Mediant 800B User Manual page 532


To configure IP-to-IP outbound manipulation rules:
1. Open the IP to IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP to IP Outbound).
2. Click Add; the following dialog box appears:
Figure 29-13: IP to IP Outbound Manipulation Page
3. Configure an IP-to-IP outbound manipulation rule according to the parameters
described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 29-9: IP to IP Outbound Manipulation Table Parameter Description
Parameter
Index
[IPOutboundManipulation_Index]
Manipulation Name
CLI: manipulation-name
[IPOutboundManipulation_Manipulatio
nName]
Matching Characteristics - Rule
Additional Manipulation
CLI: is-additional-manipulation
[IPOutboundManipulation_IsAdditional
Manipulation]
User's Manual
Mediant 800B Gateway and E-SBC
Description
Defines an index number for the new table record.
Defines an arbitrary name to easily identify the
manipulation name.
The valid value is a string of up to 20 characters. By
default, no value is defined.
Determines whether additional manipulation is done for
the table entry rule listed directly above it.

[0] No = (Default) Regular manipulation rule - not
done in addition to the rule above it.

[1] Yes = If the previous table row entry rule matched
the call, consider this row entry as a match as well and
perform the manipulation specified by this rule.
Note: Additional manipulation can only be done on a
different item (source URI, destination URI, or calling
name) to the rule configured in the row above (configured
532
- Add Dialog Box
Document #: LTRT-10278