AudioCodes Mediant 800B User Manual page 856

Parameter
[CASFileName_x]
Web/EMS: CAS Table per Channel
CLI: cas-channel-index
[CASChannelIndex]
User's Manual
ProtocolType_5 = 7
CASFileName_0='R2_Korea_CP_ANI.dat'
CASTableIndex_5 = 0
DialPlanFileName = 'DialPlan_USA.dat'
CASTrunkDialPlanName_5 = 'AT_T'
Note: The x in the ini file parameter name
denotes the trunk number, where 0 is Trunk
1.
Defines the CAS file name (e.g., 'E_M_WinkTable.dat') that
defines the CAS protocol, where x denotes the CAS file ID (0-
7). It is possible to define up to eight different CAS files by
repeating this parameter. Each CAS file can be associated
with one or more of the device's trunks, using the parameter
CASTableIndex_x.
Note: For this parameter to take effect, a device reset is
required.
Defines the loaded CAS protocol table index per B-channel
pertaining to a CAS trunk. This parameter is assigned a string
value and can be set in one of the following two formats:

CAS table per channel: Each channel is separated by a
comma and the value entered denotes the CAS table index
used for that channel. The syntax is <CAS index>,<CAS
index> (e.g., "1,2,1,2..."). For this format, 31 indices must
be defined for E1 trunks (including dummy for B-channel
16), or 24 indices for T1 trunks. Below is an example for
configuring a T1 CAS trunk (Trunk 5) with several CAS
variants:
ProtocolType_5 = 7
CASFILENAME_0='E_M_FGBWinkTable.dat'
CASFILENAME_1='E_M_FGDWinkTable.dat'
CASFILENAME_2='E_M_WinkTable.txt'
CasChannelIndex_5 =
'0,0,0,1,1,1,2,2,2,0,0,0,1,1,1,0,1,2,0,2,1,2
,2,2'
CASDelimitersPaddingUsage_5 = 1

CAS table per channel group: Each channel group is
separated by a colon and each channel is separated by a
comma. The syntax is <x-y channel range>:<CAS table
index>, (e.g., "1-10:1,11-31:3"). Every B-channel (including
16 for E1) must belong to a channel group. Below is an
example for configuring an E1 CAS trunk (Trunk 5) with
several CAS variants:
ProtocolType_5 = 8
CASFILENAME_2='E1_R2D'
CASFILENAME_7= E_M_ImmediateTable_A-Bit.txt'
CasChannelIndex_5 = '1-10:2,11-20:7,21-31:2'
Notes:

To configure this parameter, the trunk must first be
stopped.

Only one of these formats can be implemented; not both.

When this parameter is not configured, a single CAS table
for the entire trunk is used, configured by the parameter
CASTableIndex.
856
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10278