Configuring Ldap Dns (Base Paths) Per Ldap Server - AudioCodes Mediant 800B User Manual

Parameter
Use SSL
CLI:
[LdapConfiguration_us
eTLS]
Connection Status
CLI: connection-status
[LdapConfiguration_C
onnectionStatus]

15.3.4 Configuring LDAP DNs (Base Paths) per LDAP Server

The LDAP Search DN Table table lets you configure LDAP base paths. The table is a
"child" of the LDAP Configuration table (see 'Configuring LDAP Servers' on page 193) and
configuration is done per LDAP server. For the device to run a search using the LDAP
service, the base path to the directory's subtree, referred to as the distinguished name
object (or DN), where the search is to be done must be configured. For each LDAP server,
you can configure up to three base paths.
The following procedure describes how to configure DNs per LDAP server in the Web
interface. You
LdapServersSearchDNs or CLI command, configure voip/ldap/ldap-servers-search-dns.

To configure an LDAP base path per LDAP server:
1. Open the LDAP Configuration Table page (Configuration tab > VoIP menu >
Services > LDAP > LDAP Configuration Table).
2. In the LDAP Configuration table, select the row of the LDAP server for which you want
to configure DN base paths, and then click the Search DNs link (located at the bottom
of the page); the LDAP Search DN Table page opens.
3. Click Add; the following dialog box appears:
4. Configure an LDAP DN base path according to the parameters described in the table
below.
5. Click Submit, and then save ("burn") your settings to flash memory.
User's Manual
Enables the device to encrypt the username and password (for Control
and Management related queries) using TLS when sending them to the
LDAP server.

[0] No = (Default) Username and password are sent in clear-text
format.

[1] Yes
(Read-only) Displays the connection status with the LDAP server.

"Not Applicable"

"LDAP Connection Broken"

"Connecting"

"Connected"
Note: For more information about a disconnected LDAP connection, see
your Syslog messages generated by the device.
can also configure
Figure 15-7: LDAP Search DN Table - Add Record
Mediant 800B Gateway and E-SBC
Description
this using the
196
table ini file parameter,
Document #: LTRT-10278