User's Manual
48.1.3 SNMP Alarms in Syslog Messages
SNMP alerts are sent to the Syslog server using the following formats:
Raised Alarms: RAISE-ALARM: <Alarm Name>; Textual Description: <Textual
Description>; Severity <Alarm Severity>; Source <Alarm Source>; Unique ID: <Alarm
Unique ID >.
If additional information exists in the alarm, then these are also added: Additional
Info1:/ Additional Info2:/ Additional Info3
The Messages' Severity is as follows:
ITU Perceived Severity
(SNMP Alarm's Severity)
Critical
Major
Minor
Warning
Indeterminate
Cleared
Cleared Alarms: CLEAR-ALARM: <Alarm Name>; Textual Description: <Textual
Description>; Severity <Alarm Severity>; Source <Alarm Source>; Unique ID: <Alarm
Unique ID >; If exists Additional Info1:/ Additional Info2:/ Additional Info3:
48.2
Enabling Syslog
The following procedure describes how to enable and configure Syslog.
Notes:
•
For configuring CDR reporting, see ''Configuring CDR Reporting'' on page 650.
•
For viewing Syslog messages in the Web interface, see ''Viewing Syslog
Messages'' on page 679.
•
For a detailed description on the Syslog parameters, see ''Syslog, CDR and
Debug Parameters'' on page 730.
Version 6.8
Table 48-4: Syslog Message Severity
RecoverableMsg
RecoverableMsg
RecoverableMsg
Notice
Notice
Notice
673
48. Syslog and Debug Recordings
AudioCodes' Syslog Severity
Mediant 800B Gateway and E-SBC