Nat Parameters; Nfs Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
CLI: bronze-qos
[BronzeServiceClassDiffServ]

54.2.6 NAT Parameters

The Network Address Translation (NAT) parameters are described in the table below.
Parameter
Web/EMS: NAT Traversal
CLI: disable-NAT-traversal
[DisableNAT]
Web: NAT IP Address
EMS: Static NAT IP
Address
CLI: nat-ip-addr
[StaticNatIP]
Web: SIP NAT Detection
CLI: configure voip/sip-
definition advanced-
settings/sip-nat-detect
[SIPNatDetection]

54.2.7 NFS Parameters

The Network File Systems (NFS) configuration parameters are described in the table
below.
Parameter
CLI: base-port
[NFSBasePort]
NFS Table
Web: NFS Table
EMS: NFS Settings
CLI: configure
system/nfs/servers
[NFSServers]
Version 6.8
(OAMP applications).
The valid range is 0 to 63. The default is 10.
Table 54-14: NAT Parameters
Enables the NAT mechanism. For more information, see ''First Incoming
Packet Mechanism'' on page 136.

[0] Enable

[1] Disable (default)
Defines the global (public) IP address of the device to enable static NAT
between the device and the Internet.
Note: For this parameter to take effect, a device reset is required.
Enables the device to detect whether the incoming INVITE message is
sent from an endpoint located behind NAT.

[0] Disable = Disables the device's NAT Detection mechanism.
Incoming SIP messages are processed as received from endpoints
that are not located behind NAT and sent according to the SIP
standard.

[1] Enable (default) = Enables the device's NAT Detection
mechanism.
Table 54-15: NFS Parameters
Defines the start of the range of numbers used for local UDP ports used
by the NFS client. The maximum number of local ports is maximum
channels plus maximum NFS servers.
The valid range is 0 to 65535. The default is 47000.
This table parameter defines up to 16 NFS file systems so that the
device can access a remote server's shared files and directories for
loading cmp, ini, and auxiliary files (using the Automatic Update
mechanism).
The format of this table ini file parameter is as follows:
[NFSServers]
FORMAT NFSServers_Index = NFSServers_HostOrIP,
723
54. Configuration Parameters Reference
Description
Description
Description
Mediant 800B Gateway and E-SBC