AudioCodes Mediant 800B User Manual page 249

User's Manual
Notes:
•
IP Group ID 0 cannot be used. This IP Group is set to default values and is used
by the device when IP Groups are not implemented.
•
Proxy Set ID 0 must not be used with any IP Group. This Proxy Set is used for
backward compatibility (where the IsProxyUsed parameter is used).
•
If different SRDs are configured in the IP Group and Proxy Set tables, the SRD
defined for the Proxy Set takes precedence.
The following procedure describes how to configure IP Groups in the Web interface. You
can also configure IP Groups using the table ini file parameter, IPGroup or CLI command,
configure voip > control-network ip-group.

To configure an IP Group:
1. Open the IP Group Table page (Configuration tab > VoIP menu > VoIP Network >
IP Group Table).
2. Click Add; the following dialog box appears:
3. Configure an IP Group according to to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Parameter
Common Parameters
Index
[IPGroup_Index]
Version 6.8
Figure 17-5: IP Group Table - Add Dialog Box
Table 17-5: IP Group Table Parameter Descriptions
Defines an index for the new table record.
Description
249 Mediant 800B Gateway and E-SBC
17. Control Network