Auxiliary And Configuration File Name Parameters - AudioCodes Mediant 800B User Manual

54.1.7 Auxiliary and Configuration File Name Parameters

The configuration files (i.e., auxiliary files) can be loaded to the device using the Web
interface. For loading these files using the ini file, you need to configure these files in the ini
file and configured whether they must be stored in the non-volatile memory. The table
below lists the ini file parameters associated with these auxiliary files. For more information
on the auxiliary files, see ''Loading Auxiliary Files'' on page 575.
Table 54-7: Auxiliary and Configuration File Parameters
Parameter
General Parameters
[SetDefaultOnIniFileProcess] Determines if all the device's parameters are set to their defaults
[SaveConfiguration]
Auxiliary and Configuration File Name Parameters
Web/EMS: Call Progress Tones
File
[CallProgressTonesFilename]
Web/EMS: Prerecorded Tones
File
[PrerecordedTonesFileName]
Web: CAS File
EMS: Trunk Cas Table Index
[CASFileName_x]
Web: Dial Plan
EMS: Dial Plan Name
[CasTrunkDialPlanName_x]
Web: Dial Plan File
EMS: Dial Plan File Name
[DialPlanFileName]
[UserInfoFileName]
User's Manual
before processing the updated ini file.

[0] = Disable - parameters not included in the downloaded ini file
are not returned to default settings (i.e., retain their current
settings).

[1] = Enable (default).
Note: This parameter is applicable only for automatic HTTP update
or Web ini file upload (not applicable if the ini file is loaded using
BootP).
Determines if the device's configuration (parameters and files) is
saved to flash (non-volatile memory).

[0] = Configuration isn't saved to flash memory.

[1] = (Default) Configuration is saved to flash memory.
Defines the name of the file containing the Call Progress Tones
definitions. For more information on how to create and load this file,
refer to DConvert Utility User's Guide.
Note: For this parameter to take effect, a device reset is required.
Defines the name (and path) of the file containing the Prerecorded
Tones.
Note: For this parameter to take effect, a device reset is required.
Defines the CAS file name (e.g., 'E_M_WinkTable.dat'), which
defines the CAS protocol (where x denotes the CAS file ID 0 to 7).
It is possible to define up to eight different CAS files by repeating
this parameter. Each CAS file can be associated with one or more
of the device's trunks, using the parameter CASTableIndex or it can
be associated per B-channel using the parameter
CASChannelIndex.
Note: For this parameter to take effect, a device reset is required.
Defines the Dial Plan name (up to 11-character strings) per trunk.
Note: The x in the ini file parameter name denotes the trunk
number, where 0 is Trunk 1.
Defines the name (and path) of the Dial Plan file. This file should be
created using AudioCodes DConvert utility (refer to DConvert Utility
User's Guide).
Defines the name (and path) of the file containing the User
Information data.
716
Mediant 800B Gateway and E-SBC
Description
Document #: LTRT-10278