AudioCodes Mediant 800B User Manual page 863

User's Manual
Parameter
Web/EMS: Outgoing Calls Behavior
CLI: isdn-bits-outgoing-calls-behavior
[ISDNOutCallsBehavior]
Version 6.8
54. Configuration Parameters Reference
based standards (ETS 300-102 and ETS 300-403) in the
conversion of B-channel ID values into timeslot values:

In 'regular ETSI' standards, the timeslot is identical to
the B-channel ID value, and the range for both is 1 to
15 and 17 to 31. The D-channel is identified as
channel-id #16 and carried into the timeslot #16.

In newer QSIG standards, the channel-id range is 1
to 30, but the timeslot range is still 1 to 15 and 17 to
31. The D-channel is not identified as channel-id #16,
but is still carried into the timeslot #16.
When this bit is set, the channel ID #16 is considered
as a valid B-channel ID, but timeslot values are
converted to reflect the range 1 to 15 and 17 to 31.
This is the new QSIG mode of operation. When this
bit is not set (default), the channel_id #16 is not
allowed, as for all ETSI-like standards.

[64] USE T1 PRI = PRI interface type is forced to T1.

[128] USE E1 PRI = PRI interface type is forced to E1.

[256] START WITH B CHAN OOS = B-channels start in
the Out-Of-Service state (OOS).

[512] CHAN ALLOC LOWEST = CC allocates B-
channels starting from the lowest available B-channel id.

[1024] CHAN ALLOC HIGHEST = CC allocates B-
channels starting from the highest available B-channel id.

[16384] CC_TRANSPARENT_UUI bit: The UUI-protocol
implementation of CC is disabled allowing the application
to freely send UUI elements in any primitive, regardless
of the UUI-protocol requirements (UUI Implicit Service 1).
This allows more flexible application control on the UUI.
When this bit is not set (default behavior), CC implements
the UUI-protocol as specified in the ETS 300-403
standards for Implicit Service 1.

[65536] GTD5 TBCT = CC implements the VERIZON-
GTD-5 Switch variant of the TBCT Supplementary
Service, as specified in FSD 01-02-40AG Feature
Specification Document from Verizon. Otherwise, TBCT
is implemented as specified in GR-2865-CORE
specification (default behavior).
Note: When using the ini file to configure the device to
support several ISDNGeneralCCBehavior features, add the
individual feature values. For example, to support both [16]
and [32] features, set ISDNGeneralCCBehavior = 48 (i.e., 16
+ 32).
Determines several behaviour options (bit fields) that
influence the behaviour of the ISDN Stack outgoing calls. To
select options, click the arrow button, and then for each
required option, select 1 to enable. The default is 0 (i.e.,
disable).

[2] USER SENDING COMPLETE =The default behavior
of the device (when this bit is not set) is to automatically
generate the Sending-Complete IE in the Setup
message. This behavior is used when overlap dialing is
not needed. When overlap dialing is needed, set this bit
and the behavior is changed to suit the scenario, i.e.,
863
Description
Mediant 800B Gateway and E-SBC