User's Manual
54.2.3 Routing Parameters
The IP network routing parameters are described in the table below.
Parameter
Web: Send ICMP
Unreachable Messages
[DisableICMPUnreachable]
Web: ICMP Redirects
Messages
[DisableICMPRedirects]
Static Route Table
Web/EMS: Static Route
Table
CLI: configure voip > static
[StaticRouteTable]
54.2.4 Open Solution Network (OSN) Parameters
The OSN server parameters are described in the table below.
Parameter
Web: OSN Native VLAN
ID
CLI: configure system >
interface osn > native-vlan
<id>
[OSNAccessVlan]
Web: Block OSN Port
CLI: configure system >
interface osn > shutdown
[OSNBlockPort]
Version 6.8
Table 54-11: IP Network Routing Parameters
Enables sending of ICMP Unreachable messages.
[0] Enable = (Default) Device sends these messages.
[1] Disable = Device does not send these messages.
Enables sending and receiving of ICMP Redirect messages.
[0] Enable = (Default) Device sends and accepts these messages.
[1] Disable = Device rejects these messages and also does not send
them.
Defines up to 30 static IP routes for the device.
The format of the ini file table parameter is as follows:
[ StaticRouteTable ]
FORMAT StaticRouteTable_Index = StaticRouteTable_DeviceName,
StaticRouteTable_Destination, StaticRouteTable_PrefixLength,
StaticRouteTable_Gateway, StaticRouteTable_Description;
[ \StaticRouteTable ]
For a description of this parameter, see ''Configuring Static IP Routes''
on page 120.
Table 54-12: OSN Parameters
Defines the OSN Native VLAN ID.
The valid value is 0 to 4000. When set to 0 (default), the OSN uses the
device's OAMP VLAN ID. When set to any other value, it specifies a
VLAN ID configured in the Ethernet Device table and which is assigned
to a Media and/or Control application in the Interface table.
Enables or disables the Ethernet port of the internal switch that
interfaces with the OSN.
[0] Enable (default)
[1] Disable
721
54. Configuration Parameters Reference
Description
Description
Mediant 800B Gateway and E-SBC