Configuring A Layer 2 Aggregate Interface; Configuring The Description Of A Layer 2 Aggregate Interface; Specifying Ignored Vlans On A Layer 2 Aggregate Interface - HP FlexFabric 12900 Series Configuration Manual

Step
6. Assign an interface to the
specified Layer 2 aggregation
group.
7. Configure the port priority for
the interface.
8. Configure the short LACP
timeout interval (3 seconds)
on the interface.

Configuring a Layer 2 aggregate interface

Most of the configurations that can be performed on Layer 2 Ethernet interfaces can also be performed
on Layer 2 aggregate interfaces.

Configuring the description of a Layer 2 aggregate interface

You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of a Layer 2 aggregate interface:
Step
1. Enter system view.
2. Enter Layer 2 aggregate
interface view.
3. Configure the
description of the
aggregate interface.

Specifying ignored VLANs on a Layer 2 aggregate interface

By default, to become Selected ports, the member ports must have the same VLAN permit state and
VLAN tagging mode as the corresponding Layer 2 aggregate interface.
Command
a. Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b. Assign the interface to the
specified Layer 2
aggregation group:
port link-aggregation
group number
link-aggregation port-priority
port-priority
lacp period short
Command
system-view
interface bridge-aggregation
interface-number
description text
47
Remarks
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.
The default setting is 32768.
By default, the long LACP timeout
interval (90 seconds) is adopted by
the interface. The peer sends
LACPDUs slowly.
Remarks
N/A
N/A
By default, the description of an
interface is in the format of
interface-name Interface.