Eaton EDR-5000 Nstallation, Operation And Maintenance Manual page 348

Options of the DNP
Name
-.-
Prot.FaultNo
Prot.No of GridFaults
Bkr.TripCmd Cr
LVRT [1].NumOf Vdips in t-
LVRT
LVRT [1].Cr Tot Numb of Vdips Counter Total number of voltage dips.
LVRT [1].Cr Tot Numb of Vdips
to Trip
LVRT [2].NumOf Vdips in t-
LVRT
LVRT [2].Cr Tot Numb of Vdips Counter Total number of voltage dips.
LVRT [2].Cr Tot Numb of Vdips
to Trip
AR.AR Shot No.
AR.Total number Cr
AR.Cr successfl
AR.Cr failed
AR.Cr Service Alarm1
AR.Cr Service Alarm2
AR.Max Shots / h Cr
ECr.Wh Fwd
ECr.Wh Rev
ECr.VArh Lag
ECr.VArh Lead
Sys.Operating hours Cr
Selectable Switchgears of the DNP
Name
-.-
Bkr.State
Description
No assignment
Waveform No.
Number of grid faults: A grid fault, e.g. a short circuit, might cause several faults with trip and autoreclosing,
each fault being identified by an increased fault number. In this case, the grid fault number remains the same.
Counter: Total number of trips of the switchgear (breaker, load break switch...). Resettable with Total or All.
Number of Voltage dips during t-LVRT
Counter Total number of voltage dips that caused a Trip.
Number of Voltage dips during t-LVRT
Counter Total number of voltage dips that caused a Trip.
Counter - Auto Reclosure Attempts
Total number of all executed Automatic Reclosures Attempts
Total number of successfully executed Automatic Reclosures
Total number of unsuccessfully executed automatic reclosure attempts
Remaining numbers of ARs until Service Alarm 1
Remaining numbers of ARs until Service Alarm 2
Counter for the maximum allowed shots per hour.
Positive Active Power is consumed active energy
Negative Active Power (Fed Energy)
Positive Reactive Power is consumed Reactive Energy
Negative Reactive Power (Fed Energy)
Operating hours counter of the protective device
Description
No assignment
Signal: Breaker Position (0 = Indeterminate, 1 = OPEN, 2 = CLOSE, 3 = Disturbed)
www.eaton.com
EDR-5000 IM02602007E
348