Eaton EDR-5000 Nstallation, Operation And Maintenance Manual page 260

Parameter Description
Physical Settings Digit 1: Number of bits. Digit 2: E=even parity, O=odd
parity, N=no parity. Digit 3: Number of stop bits. More
information on the parity: It is possible that the last data
bit is followed by a parity bit which is used for recognition
of communication errors. The parity bit ensures that with
even parity ("EVEN") always an even number of bits with
valence "1" or with odd parity ("ODD") an odd number of
"1" valence bits are transmitted. But it is also possible to
transmit no parity bits (here the setting is "Parity =
None"). More information on the stop-bits: The end of a
data byte is terminated by the stop-bits.
t-call If there is no request message sent from Communication
to the device after expiry of this time, the device
concludes a communication failure within the
Communication system.
Comm CmdBlo Activating (allowing)/ Deactivating (disallowing) the
blocking of the Communication Commands
Disable Latching Disable Latching: If this parameter is active (true), none
of the Modbus states will be latched. That means that trip
signals wont be latched by Modbus.
AllowGap If this parameter is active (True), the User can request a
set of modbus register without getting an exception,
because of invalid address in the requested array. The
invalid addresses have a special value 0xFAFA, but the
User is responsible for ignoring invalid addresses.
Attention: This special value can be valid, if address is
valid.
Optical rest position Optical rest position
Config Bin Inp1 Virtual Digital Input. This corresponds to a virtual binary
output of the protective device.
EDR-5000
Setting range
8E1,
8O1,
8N1,
8N2
1 - 3600s
Inactive,
Active
Inactive,
Active
Inactive,
Active
Light off,
Light on
1..n, Assignment
List
www.eaton.com
IM02602007E
Default Menu path
8E1 [Device Para
/Modbus
/Communication]
10s [Device Para
/Modbus
/Communication]
Inactive [Device Para
/Modbus
/Communication]
Inactive [Device Para
/Modbus
/Communication]
Active [Device Para
/Modbus
/Communication]
Light on [Device Para
/Modbus
/Communication]
SSV.System Error [Device Para
/Modbus
/Configb Registers
/States]
260