AudioCodes Mediant 800B User Manual page 1090

Parameter
[EnableAOC]
Add IE in SETUP
add-ie-in-setup
[AddIEinSetup]
Trunk Groups to Send IE
trkgrps-to-snd-ie
[SendIEonTG]
Enable User-to-User IE for
Tel to IP
uui-ie-for-tel2ip
[EnableUUITel2IP]
Enable User-to-User IE for IP
to Tel
uui-ie-for-ip2tel
[EnableUUIIP2Tel]
User's Manual
to SIP.

[0] Disable (default)

[1] Enable
For more information on AOC, see ''Advice of Charge Services for
Euro ISDN'' on page 562.
Global parameter that defines an optional Information Element (IE)
data (in hex format) to add to ISDN Setup messages. You can also
configure this functionality per specific calls, using IP Profiles
(IpProfile_AddIEInSetup). For a detailed description of the parameter
and for configuring this functionality in the IP Profile table, see
''Configuring IP Profiles'' on page 396.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with
the IP Profile.
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is sent.
For example: '1,2,4,10,12,6'.
Notes:

You can configure different IE data for Trunk Groups by defining
the parameter for different IP Profile IDs (using the parameter
IPProfile), and then assigning the required IP Profile ID in the IP to
Trunk Group Routing table (PSTNPrefix).

When IP Profiles are used for configuring different IE data for
Trunk Groups, the parameter is ignored.
Enables transfer of User-to-User (UU) IE from ISDN PRI to SIP.

[0] Disable (default)

[1] Enable
The device supports the following ISDN PRI-to-SIP interworking:
Setup to SIP INVITE, Connect to SIP 200 OK, User Information to
SIP INFO, Alerting to SIP 18x response, and Disconnect to SIP BYE
response messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI variants.
Enables interworking of SIP user-to-user information (UUI) to User-to-
User IE in ISDN Q.931 messages.

[0] Disable = (Default) Received UUI is not sent in ISDN message.

[1] Enable = The device interworks UUI from SIP to ISDN
messages. The device supports the following SIP-to-ISDN
interworking of UUI:

SIP INVITE to Q.931 Setup

SIP REFER to Q.931 Setup

SIP 200 OK to Q.931 Connect

SIP INFO to Q.931 User Information

SIP 18x to Q.931 Alerting

SIP BYE to Q.931 Disconnect
Notes:

The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI variants.

To interwork the UUIE header from SIP-to-ISDN messages with
the 4ESS ISDN variant, the ISDNGeneralCCBehavior parameter
1090
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296